A SITE-SPECIFIC SAFETY PLAN FOR THE REPAINTING OF THE 59TH STREET BRIDGE
FOR DECOLORES PAINTING CO., INC.
| Project Manager: Phil Adelphia | Phone: 1-800-BYE-LEAD |
| Site Supervisor: Sandy Francisco | Phone: 1-301-CEL-PHON |
WORK FLOW SAFETY PLAN
|
ACTIVITY
|
HAZARDS
|
PROGRAMS/
CONTROLS |
RESPONSIBLE
INDIVIDUAL(S)
|
| 1. Establish
Work Zones: A combination of Barrels, Advance Warning signs, and concrete
barriers will be used to establish the work zone boundaries. |
1. Errant
Vehicles 2. Worksite Motor Vehicles (Falls, Struck-by) |
1A. Manual
on Uniform Traffic Control Devices, Part VI 1B. Visible clothing/vests 2A. Motor Vehicle Safety Program |
Site Supervisor/DOT
Engineer Site Supervisor Site Supervisor |
| 2. Erect Containment:
Cable-supported bridge-to-grade containment will be used. Access to bridge
structures will be by truck-mounted extendable lift. |
A. Falls B. Electrocution |
A1. Personal Fall arrest
systems will be used on all fall exposures over six feet, including work
in the man-lifts. B. Re-route All Overhead Power Lines near bridge structure |
A1. Erecting Containment:
Site Supervisor A2. Assuring Ventilation rates and Containment sufficiency: IH Contractor B. DOT( Owner) |
| 3. Blast and Clean
Structure: The structural steel elements will be blasted to near-white metal using steel shot abrasive. Abrasive will be vacuumed from the bottom of the containment area, classified, and re-used. An air filtration system will be used for dust control in the enclosure. Tarps will be white allowing natural light to penetrate into the enclosure. |
A. Health Hazards (Lead,
Silica, Metal Fumes, Noise) B. Falls |
A1. Lead Compliance
Program A2. Respiratory Protection Program A3. Hearing Protection Program B1. Fall Protection Program B2. Ladder Safety Program |
Site Supervisor, IH
Consultant |
| 4. Repaint Structure:. Non-lead primers and finishes will be applied to the structures by a pneumatic pump type airless spray system. Painting will be done inside the containment to confine overspray. Other areas will be painted by brush. | A. Fire, Flammables B. Solvent Exposures |
A. Use only pneumatic
tools B. Respiratory Protection Program (Pressure Demand Airline Respirators) |
A. Site Supervisor B. IH Consultant |
| 5. Dismantle
Site: Equipment will be vacuumed prior to removal from the site. Spent abrasives and lead contaminated PPE will be disposed of as lead-contaminated waste by XYZ Environmental Co. |
A. Falls B. Health Hazards (Lead, Silica Dusts) C. Errant Vehicles |
A1. Fall
Protection Program A2. Ladder Safety Program B1. Lead Compliance Plan B2. Respiratory Protection Program C. Work-zone Safety Program (MUTCD) |
A. Site
Supervisor B. IH Consultant C. Site Supervisor/DOT |
SITE EMERGENCY/RESCUE PROVISIONS:
Evacuation: An evacuation signal of three short blasts followed by three long blasts of the company equipment truck will alert employees outside of containment of the need to evacuate the area. Because they cannot hear external audible alarms, employees inside the containment area will be alerted to the need to evacuate by signaling through the blast nozzle, closing the nozzle supply valve at the pot according to the same signal above. Evacuating employees will meet at the hygiene trailer for further instructions.
Fall Protection Rescue: Employees who are suspended by lanyards after a fall will be winched to safety using a portable winch if they are conscious. The aerial lift or outside rescue services may also be used to effect a rescue.
Fire: Employees are expected to fight small, incipient stage fires according
to training provided. ABC Fire extinguishers will be located in the hygiene
trailer and in company vehicles.
First Aid and Emergency Care: A first aid kit will be maintained by the Site
Supervisor. At least one employee who has received basic first-aid training
will be on site at all times. Minor care can be obtained by taking employees
to the Fix-em Minor Emergency Care Center located three blocks from the site
on 62nd Avenue. EMT services should be accessed by cellular phone by calling
911. EMTs should be directed to take employees to the Good Samaritan Hospital
nearest the worksite.
TRAINING MODULES NECESSARY FOR ALL EMPLOYEES ON THE SITE:
| Hazard communication | Hearing conservation |
| Respiratory protection | Hand-tool safety |
| Lead training | Flammable liquids |
| Basic fall protection | Incipient fire-fighting |
| Ladder safety | Evacuation/first-aid/rescue |
| Basic electrical safety | Aerial lift safety |
| Personal protective equipment | Rigging/wire rope fundamentals |
| Work-zone safety |
SPECIALIZED TRAINING REQUIRED: Blasters: Abrasive Blasting Safety, Respirator Supplied Air Quality Fundamentals
NECESSARY COMPETENT/QUALIFIED PERSONS: See Attached Assignment Sheets
MEETINGS:
|
Meeting:
|
Participants:
|
|
| Prepare Site-specific Safety Plan | Project Management, Safety | |
| Pre-bid meeting to identify hazards and cost out control/protection costs | Project
Management, Safety, Accounting |
|
| Pre-job safety meeting to review/modify the Site-specific Safety Plan Safety Personnel, | Project Manager, Joint S/H Committee, Site Supervisor, DOT | |
| Pre-job
safety modules training (see above) |
Project Mgr., Safety Personnel, Site Supervisor, Employees | |
| Monthly
Project Safety Mtg. |
Project Mgr., Joint S/H Committee, Site Supv., Safety Personnel, DOT | |
| Weekly Toolbox | Site Supervisor, Employees | |
| Post-job
Assessment |
Project Manager, Safety Personnel, Site Supervisor, DOT |
SITE INSPECTIONS:
Jobsite inspections will be conducted weekly by a three person team consisting of Les Risk, Safety Director, Sandy Francisco, Site Supervisor and a rotating member of the Joint S/H Committee.
ATTACHMENTS:
Written Hazard Communication Program
Written Lead Compliance Plan
Written Respirator Program
Competent/Qualified Persons Designation Forms
COMPETENT PERSON ASSIGNMENT FORM
PROJECT: 59th Street Bridge Repair and Repainting
SENIOR PROJECT MANAGER: Phil Adelphia
The following activities require the oversight of designated competent persons. A competent person is someone who is capable of identifying existing and predictable hazards in the surroundings or working conditions that are unsanitary, hazardous, or dangerous to employees, and who has authorization to take prompt corrective measures to eliminate them. The following marked activities are applicable to this project, and the designated competent person for the activity is listed.
|
Subpart/Activity
|
Applies?
|
Designated
Competent Person(s)
|
| 1926. 20:
Jobsite Inspections |
X
|
Site Supv: Sandy Francisco |
| 1926.53: Ionizing Radiation | ||
| 1926.62:
Lead Compliance Plan/IH |
X
|
Safety Mgr.: Les Risk |
| 1926.101: Hearing Conservation/IH |
X
|
Safety Mgr.: Les Risk |
| 1926.103:
Respiratory Protection/IH |
X
|
Safety Mgr.: Les
Risk |
| 1926.251: Rigging/Materials Handling |
X
|
Sandy Francisco, Les Risk |
| 1926.354: Welding/IH | ||
| 1926.404:
Electrical Grounding Assurance |
Not NecessaryCGFCIs used throughout site | |
| 1926.451: Scaffolding | ||
| 1926.500-503: Fall Protection |
X
|
Les Risk, Sandy Francisco |
| 1926.550: Cranes-Annual Inspection | ||
| 1926.552: Hoists-Inspections and Tests |
X
|
Les Risk, Sandy Francisco |
| 1926.650-652: Trenching and Excavation | ||
| 1926.705: Lift-slab Construction | ||
| 1926.752: Ironwork/Structural Steel | ||
| 1926.800-803: Underground Construction | ||
| 1926.850-859: Demolition | ||
| 1926.900: Blasting | ||
| 1926.1053-1060: Ladders |
X
|
Les Risk, Sandy Francisco |
| 1926.1101: Asbestos | ||
| 1926.1127: Cadmium |
QUALIFIED PERSON DESIGNATION FORM
PROJECT: 59th Street Bridge Repair and Repainting
SENIOR PROJECT MANAGER: Phil Adelphia
The following activities require the oversight or participation of designated qualified persons. A qualified person is one who is familiar with the construction and operation of equipment and the hazards involved in the use of the equipment. Additionally, a qualified person is one who by reason of experience or training is familiar with the operation to be performed and the hazards involved.
The following marked activities are applicable to this project, and the designated qualified person(s) for the activity is/are listed.
|
Subpart/Activity
|
Applies?
|
Designated
Qualified Person(s)
|
| 1926.54: Laser Operations | ||
| 1925.55: Assessment of Exposures to Gases, Vapors Fumes, Dusts and Mists |
X
|
Consultants:
Industrial Hyenas Consulting Co./L.D. Fiftee CIH |
| 1926.65: Hazardous Waste Operations and Emergency Response | ||
| 1926. 403-449: Electrical Safety |
X
|
Safety Director: Les Risk |
| 1926.500-503: Fall Protection |
X
|
Safety Director: Les Risk |
| 1926.550: Cranes and Derricks | ||
| 1926.701: Concrete and Masonry Construction | ||
| 1926.800: Underground Construction | ||
| 1926.900: Blasting and Explosives | ||
| 1926.960: Electrical Power Transmission and Distribution |